Carf-Models P-47 Thunderbolt Instruction Manual page 59

CARF-Models P-47
www.carf-models.com
NOTE the distance from the bottom edge NOTE that hinge end must be cut off where it
of strut cover to hinge pivot point – extends beyond the edge of the gear cover.
Approx. 6mm (1/4")
When satisfied with the fit and operation, glue components with a mixture of epoxy and cut glass.
The gear cover opening must be cut out to accommodate the hinge pin:
Expect some interference between the strut cover and wheel cover. This is normal and can be
remedied by sanding a bevel in the lower edge of the strut cover.
59