Advertisement
CARF-Models P-47
The finished exhaust extensions are approximately 12 inches (30cm) long. Cut the copper stock
so that there is plenty of material with which to work.
Trim tubing length to fit into the tapered end such that when inserted into exhaust exit, it is
flush with fuselage. Mark the exact location of the tapered end, remove and
**hard solder - using alloys that melt at greater than 450 degrees C. This includes brazing
and high temperature solders. 'Hobbyist' solder will not survive Moki exhaust temperatures.
www.carf-models.com
**hard solder.
91
Advertisement
