Advertisement
CARF-Models P-47
www.carf-models.com
Horizontal Stab and Elevators
NOTE: Remove torque rod arm retention nut, apply
thread-locking compound, and re-tighten.
Locate the 20mm x 380mm aluminum stab tube. Remove
the stab retention bolts from the tube and slide tube into
position. The left and right stab and elevator assemblies
should be trial fit. Using a bright light, check to make sure
the threaded holes in the stab tube are perfectly aligned
with stab holes so that retention screws are easily inserted
and secured. DO NOT force these bolts. If they do not
thread in easily, check and adjust alignment until they do.
DO NOT cross-thread or in any way force stab or
elevator bolts when installing. IF any resistance is
encountered, REMOVE stab and elevator and verify bolts
will easily thread into their respective locations.
Elevator retention bolts are threaded into the carbon fiber elevator torque rod. It is equally
important that you NOT cross-thread or in any way force these bolts! If necessary, remove
30
Advertisement
