Advertisement
CARF-Models P-47
www.carf-models.com
TW gear doors - addendum
The gear door hinge pins are not glued at the factory to allow the builder to remove the doors for
painting. It is also recommended that you remove these hinge pins and lubricate them for easier
gear door actuation. When you no longer need to remove the gear doors, glue the hinge pins so
that they cannot come out in flight.
Epoxy to side
Scale exhaust cooling – addendum
It is recommended that you open up the firewall near the scale exhaust tubes to allow cooling air
to enter the nose of the aircraft. The heated air can then exit the oil cooler openings.
BE SURE
to
remove ALL dust and debris! Your engine deserves only CLEAN AIR!
110
Advertisement
