Advertisement
CARF-Models P-47
NOTE: Due to the location of the rudder tray, this is admittedly a challenging
procedure! Take your time; do it right. Check the cable lengths several times
When checking cable length and pulling cable tight, Rudder servo arm MUST
remain stationary and neutral. A servo driver is very helpful in powering servo and
holding at neutral position. You may also connect your receiver and battery to
CHECK that the Rudder servo is centered, with trims centered BEFORE making
After pulling cable, remove and see the bend in the cable marking the area where it will be
looped at the servo ball link eyelet. Using the same technique as that used for securing cables at
the tail wheel tiller arm, the cable is looped back through the swage and crimped flat with pliers
and the excess cable is cut off.
Perform this same procedure with the other tail wheel cable, making sure the tail wheel and
rudder servo are CENTERED BEFORE crimping and cutting.
BEFORE pulling loops tight and crimping.
accomplish this.
cable measurements.
www.carf-models.com
26
Advertisement
