Advertisement
CARF-Models P-47
www.carf-models.com
Scale Exhaust
The P-47 had exhaust 'waste gates' directly behind the oil coolers on the front lower section of
the nose. These were opened when manifold pressure was too high; excess exhaust pressure was
diverted from the Turbo-Supercharger. The location of these waste gates lend themselves
perfectly to scale exhaust outlets.
The prototype CARF-Models Thunderbolt utilized canister headers for exhaust extensions.
Another option is corrugated copper pipe
utilized for hot water heater installations and
@US
found at most home improvement and hardware stores
.
@US
The Moki exhaust outlets are 20mm (3/4 inch) in diameter.
The large end is cut off then cut again to form the tapered exhaust exit.
The location of the exhaust outlets is as follows:
90
Advertisement
