Advertisement
CARF-Models P-47
www.carf-models.com
WINGS – Ailerons
NOTE: Please check ALL hinges on both ailerons and flaps for the installation of 'E' clip
retainers. While CARF quality checks are thorough, they are not perfect. IF any clips or hinge
pins are missing, contact your CARF Sales Rep for immediate replacement.
Locate the Aileron Hardware bag (120mm threaded rods) and assemble aileron pushrods as
shown. For correct control geometry, a very short servo horn will be employed and the inner-
most servo arm hole utilized.
Some hardware installation challenges are inherent in any highly prefabricated scale aircraft.
Aileron servo installation will require a special tool to access aileron servo screws. The preferred
'tool' is to create an exceptionally long Philips head screw driver. It must reach a minimum of 35
cm and also be slender enough to fit between the flap pivot points.
38
Advertisement
