Advertisement
CARF-Models P-47
Strut Covers
Clamp the strut cover to the strut so that an approximate position for the hinge wire and sleeve
can be located and marked on the inside of the strut cover. Once satisfied with the positioning,
the sleeve can be epoxied. Use sand paper to rough up the gluing surfaces of both the strut cover
and hinge pin sleeve. Clean with alcohol then glue with a mixture of epoxy and cut glass to create
a stronger bond.
BUILDERS TIP: All of the strut cover bonds can be made temporarily with small amounts
of CA glue and Accelerator, until the final positions are achieved
Fitting strut covers requires PATIENCE. There is no specific
manner in which to guarantee a perfect fit...this is a trial and error
process in which you "creep up" on the proper fit. However, the
following photos and tips will minimize the potential for errors!
From the Wing hardware bag, locate the strut cover hinge wire and
sleeve. The hinge wire is inserted in the sleeve and bent as shown
below so that it matches the exact width of the strut cover ball links
mounted on the landing gear strut.
www.carf-models.com
55
Advertisement
