Carf-Models P-47 Thunderbolt Instruction Manual page 58

CARF-Models P-47
www.carf-models.com
The hinge pin wire is cut to length a little bit at a time until the proper length is achieved such
that the strut cover will lay perfectly flat when the gear are fully retracted:
Make SMALL cuts to
achieve correct length
Locate the large Robart hinge point from the hardware pack. Drill a hole at the base of the strut
cover as shown. The hinge point should be temporarily attached and the strut cover taped to the
gear cover. NOTE THE LOCATION OF THE HINGE PIVOT POINT – the pivot point of the
hinge should be 6mm from the edge of the strut cover. This is necessary to provide the proper
clearance as the strut cover pivots with the gear. When positioned properly, the strut cover can
be opened and closed without contacting the gear cover at its base/pivot point.
58