Furuno Felcom 250 Service Manual page 188

Setup item
Enter the User account and Password specified by the provider. If you
User account
enter incorrect data, you will not be able to connect with the provider.
If no user account or password is specified by the provider, leave these
Password
fields blank.
Select the name of the connection target provider.
If you turn the power of the system on, the provider name will be read
APN
from the SIM card, and (SIM) will be attached at the beginning of the
(Access Point
name; select this APN.
Name)
Display example: (SIM)bgan.inmarsat.com.
Furthermore, you can add/edit APN.
Auto connection If you place a tick for "Enable," connection with "Standard IP data" will
Note 1)
be automatically established when the power is turned on.
If a tick is placed for "Enable," automatic reconnection function will be
activated.
Persistent Automatic reconnection function is a function which automatically
reestablishes connection with the originally connected service in case
the network for that service had been disconnected for some reason.
This is a setting for automatic disconnection function. If you have
Auto disconnection placed a tick for "Enable," make sure to set the following conditions.
Note 2)
IP address Set this to Auto in normal cases.
Enter the address specified by the provider.
DNS server
Note 1) Auto connection
Standard IP data is billed by the packet data volume. If you have auto connection
established, your PC may start downloading program updates and other files
automatically as long as you are connected to the Internet (WAN) even if you do not
execute any PC operation, so it may be better if you do not set "Auto Connection" to
"Enabled".
Note 2) Auto disconnection
The services automatically connected under the preset conditions will be disconnected.
Condition:
- Any time : Regardless of whether any data is sent/received, the connection will
- No Tx & Rx, : The connection will be automatically disconnected after the time
- No Tx, : The connection will be automatically disconnected after the time
- No Rx : The connection will be automatically disconnected after the time
Waiting time:
Set the time to be defined from when the preset "Condition" is established until
disconnection is executed.
- Condition: Any time, No Tx&Rx, No Tx, No Rx
- Waiting time xx min (0000 - 9999)
be automatically disconnected after the time set in Waiting time has
passed since the connection had been established.
set in Waiting time has passed since no data has been sent/received.
set in Waiting time has passed since no data has been sent.
set in Waiting time has passed since no data has been received.
Notes
5-5
5.1 WAN Settings