A.c. Generator Inspection; Cdi Unit Inspection - KYMCO DINK 200 Manual

17
. IGNITION SYSTEM

A.C. GENERATOR INSPECTION

EXCITER COIL/PULSER COIL
INSPECTION
This test is performed with the stator
installed in the engine.
Remove the frame right cover. (  2-4)
Disconnect the A.C. generator connector.
Measure the exciter coil resistance between
the black/red wire terminal and ground.
Black/red Ground
Measure the resistance in the XΩ range.
For A.C. generator removal/installation, refer
to pages 10-3 and 10-6.
Disconnect the pulser coil wire coupler.
Measure the pulser coil resistance between
the blue/white and green/white wire terminals.
Blue/white Green/white 50
For pulser coil replacement, refer to pages 10-
3 and 10-6.

CDI UNIT INSPECTION

Remove the met-in box. (  2-3)
Disconnect the CDI coupler and remove the
CDI unit.
Inspect the CDI unit performance using the
CDI tester.
Correctly operate the CDI tester following
the manufacturer's instructions.
Connect the CDI unit to the CDI tester
special coupler (KB7). Adjust the CDI tester
switch range.
Switch Good CDI
1. OFF No spark
2. P
3. EXT
4. ON1 Good spark
5. ON2 Good spark
50 350Ω
170Ω
Faulty CDI

↑ 
Good spark
↑
No spark
No spark
A.C. Generator Connector
Pulser Coil Wire Coupler
DINK 200
17-4