KYMCO DINK 200 Manual page 175

14
. STEERING HANDLEBAR/FRONT WHEEL/FRONT
BRAKE/FRONT SHOCK ABSORBER/FRONT FORK
Connect the front stop switch wire
connector.
Install the handlebar covers. (  2-6)
BRAKE FLUID REFILLING
Keep the handlebar upright and remove the
brake reservoir cover and diaphragm.
Add DOT-3 brake fluid to the brake
reservoir.
• When bleeding, be careful not to allow
air in the brake reservoir flowing into
the brake system.
• When using a brake bleeder, follow the
manufacturer's instructions.
• Never use dirty or unspecified brake
fluid or mix different brake fluids be-
cause it will damage the brake system.
BRAKE FLUID BLEEDING
Keep the handlebar upright and remove the
brake reservoir cover and diaphragm. Add the
specified brake fluid to the upper limit.
• Do not allow dust or water to enter the
brake system during refilling.
• When servicing the brake system, use
shop towels to cover plastic parts and
coated surfaces to avoid damage caused
by splash of brake fluid.
In order to avoid spilling brake fluid, connect
a transparent hose to the bleed valve.
Warning
Brake fluid spilled on brake pads or
brake disk will reduce the braking effect.
Clean the brake pads and brake disk with
a high quality brake degreaser.
Fully apply the brake lever and then loosen
the brake caliper bleed valve to drain the
brake fluid until there is no air bubbles in the
brake fluid. Then, tighten the bleed valve.
Repeat these steps until the brake system is
free of air.
Stop Switch Wire Connector
Bleed Valve
DINK 200
14-10