Ac Generator - Exciter Coil/Pulser Coil Inspection - KYMCO Like 50 Service Manual

15
. ELECTRICAL EQUIPMENT
Performance Test
Remove the ignition coil.
Inspect the ignition coil with an ignition coil
tester.
＊
Follow the ignition coil tester manufac-
turer's instructions.
1. Turn the changeover switch to 12V and
connect the ignition coil to the tester.
2. Turn the power switch ON and check the
spark from the watch window.
‧Good : Normal and continuous spark
‧Faulty : Weak or intermittent spark
＊
The test is performed at both conditions
that the ignition coil is cold and hot.
A.C. GENERATOR
Exciter Coil/Pulser Coil Inspection
＊
This test is performed with the stator
installed in the engine.
Remove the met-in box. ( 12)
Disconnect the A.C. generator wire
connector.
Measure the pulser coil resistance between
the blue/yellow wire and ground.
Resistance (20℃): 100～150Ω
9
LIKE 50/125
Ignition Coil