A .C. Generator Inspection; Crank Position Sensor Inspection; Angle Detect Sensot - KYMCO Super 8 50 Service Manual

15
. IGNITION SYSTEM

A .C. GENERATOR INSPECTION

CRANK POSITION SENSOR INSPECTION

＊
This test is performed with the stator
installed in the engine.
Remove the seat and met-in box.
Disconnect the Crank Position Sensor Wire
Coupler.
Measure the resistance
blue/white and green/white wire terminals.
Blue/Yellow～Green/White

ANGLE DETECT SENSOT

INSPECTION
Support the scooter level surface.
Put the side stand up and engine stop switch
is at "RUN".
Turn the ignition switch to "OFF".
Remove the screws, washers and tilt switch.
＊
Do not disconnect
connector during inspection.
The capacity of battery must be fully
charged.
Place the tilt switch vertical as shown at the
ignition switch "ON". Measure the voltage as
below.
Terminal
Violet/Red
(+) –Violet/Green (-)
Black/White
(+) –Violet/Green (-)
Incline the tilt switch 65±10 degrees to the
left or right at the ignition switch "ON".
Measure the voltage as below.
Terminal
Violet/Red
(+) –Violet/Green(-)
Black/White
(+) –Violet/Green (-)
If repeat this test, first turn the ignition switch
to "OFF", then turn the ignition switch to
"ON".
5
between the
96~144Ω
the tilt switch
Standard
5 V (ECU voltage)
0.4～1.44 V less
Standard
5 V (ECU voltage)
3.7～4.4 V
Super 8 50
Crank Position Sensor Wire Coupler
Tilt Switch "UP" Mark
Connector