Lights - KYMCO DINK 200 Manual

19
. SWITCHES/HORN/FUEL UNIT/THERMOSTATIC SWITCH
DINK 200
/TEMPERATURE GAUGE/INSTRUMENTS/LIGHTS
Wire

LIGHTS

HEADLIGHT BULB REPLACEMENT
Remove the front upper cover. (  2-5)
Disconnect the headlight and turn signal light
wire couplers.
Remove the rubber boot from the bulb socket.
Remove the bulb socket and replace the bulb.
Install the bulb socket, aligning the bulb
socket tab with the groove.
Install the rubber boot.
Bulb Socket
Install the front cover in the reverse order of
removal.
Wire
FRONT POSITION LIGHT BULB
REPLACEMENT
Remove the front upper cover. (  2-5)
Disconnect the headlight and turn signal light
wire couplers.
Remove the bulb sockets by turning them
counterclockwise.
Remove the bulbs and replace them with new
ones.
Front Position Light Bulb Sockets
FRONT TURN SIGNAL LIGHT BULB
REPLACEMENT
Remove the two screws attaching the turn
signal light shell and remove the light shell.
Remove the bulb and replace with a new one.
Screws
TAILLIGHT/REAR TURN S IGNAL LIGHT
BULB REPLACEMENT
Remove the rear protective cover. (  2-3)
Remove the two screws attaching the rear
light shell and remove the light shell.
Remove the bulbs and replace with new ones.
The installation sequence is the reverse of
removal.
Screws
19-8