Front Wheel - KYMCO DINK 200 Manual

14
. STEERING HANDLEBAR/FRONT WHEEL/FRONT
BRAKE/FRONT SHOCK ABSORBER/FRONT FORK
Lubricate the throttle grip front end with
grease and then install the throttle grip.
Connect the throttle cable to the throttle grip.
Install the right and left handlebar switches
and tighten the screws.
• Adjust the throttle grip free play to the
specified range of 2
Install the front and rear brake master
cylinders.
• Install the brake master cylinders by
aligning the index marks.

FRONT WHEEL

REMOVAL
Jack the motorcycle front wheel off the
ground.
Remove the front axle nut to pull out the axle.
Remove the front wheel and the speedometer
gear unit.
INSPECTION
AXLE RUNOUT
Set the axle in V blocks and measure the
runout using a dial gauge.
The actual runout is _ of the total indicator
reading.
Service Limit: 0.2mm replace if over
14-5
6mm.
Throttle Grip
Throttle Cable
Brake Master Cylinder
Bolt
Speedometer Gear Unit
Axle Nut
DINK 200