Regulator/Rectifier Inspection - KYMCO DINK 200 Manual

16
. BATTERY/CHARGING SYSTEM
A.C. GENERATOR REMOVAL
A.C. generator removal (  10-3)
A.C. generator installation (  10-6)
REGULATOR/RECTIFIER
INSPECTION
Remove the frame front cover. (  2-5)
Remove the regulator/rectifier wire coupler.
Check the continuity between the wire
terminals.
Normal Direction: Continuity
(+) Probe
I
II Red/White
Reverse Direction: No Continuity
(+) Probe
I
II
VOLTAGE REGULATION TEST
Connect a voltmeter across the battery
terminals.
Start the engine and gradually increase the
engine speed.
The battery terminal voltage should be within
14.0 15.0V.
(-) Probe
Yellow Green
Yellow
(-) Probe
Green Yellow
Yellow Red/White
Pulser Coil
A.C. Generator Stator
Right Crankcase Cover
Red/White
Normal
Direction
Green
Voltage Sensor
DINK 200
Bolts
Reverse
Direction
Black
16-6