Reed Valve - KYMCO DINK 200 Manual

20
. EXHAUST EMISSION CONTROL
SYSTEM

REED VALVE

REMOVAL
Remove the frame center cover.
Remove the floor board cover.
Disconnect the secondary air inlet tube
connector.
Remove the reed valve cover three bolts and
two secondary air outlet tube bolts.
Remove the three bolts attaching the reed
valve cover and the reed valve.
INSPECTION
Check the reed valve for cracks, damage, big
clearance or weak reeds. Replace if
necessary.
Check the gasket and O-ring for damage or
deterioration and replace if necessary.
Reed valve stopper clearance: 4.6mm
INSTALLATION
Install the reed valve in the reverse order of
removal.
• When installing, be careful not to bend
or twist the tubes and check for
proper installation.
20-4
Reed Valve Cover
Bolt
Secondary Air Inlet Tube Bolt
Reed Valve
Reed Stopper
DINK 200
Cylinder Head Cover
Bolt