Flywheel Installation - KYMCO DINK 200 Manual

10
. A.C. GENERATOR/STARTER CLUTCH
Remove the flywheel.
Inspect each roller for wear or damage.
INSTALLATION
Install the starter driven gear onto the
crankshaft.
Install the starter idle gear and shaft.

FLYWHEEL INSTALLATION

Install the flywheel onto the crankshaft by
aligning the key on the crankshaft with the
groove in the flywheel.
• Before installation, check and make
sure that the inside of the flywheel is
not contaminated.
Hold the flywheel with the flywheel holder
and tighten the flywheel nut.
Torque: 34.3 39.2N-m
10-5
Flywheel
Roller
Shaft
Starter Driven Gear
Starter Idle Gear
Groove
Key
Flywheel Holder
DINK 200
One-way Clutch
Flywheel