Cooling System Testing; Radiator - KYMCO DINK 200 Manual

12
. COOLING SYSTEM

COOLING SYSTEM TESTING

RADIATOR CAP INSPECTION
Install the radiator cap onto the radiator
tester and apply specified pressure to it. It
must hold specified pressure for at least six
seconds.
Apply water to the cap sealing surface
before testing.
Radiator Cap Relief Pressure:
0.9±0.15kg/cm_
Install the radiator tester onto the radiator
and apply specified pressure to it. It must
hold specified pressure for at least six
seconds.
Check the water hoses and connectors for
leaks.
The test pressure should not exceed 1.05
kg/cm_. Excessive pressure can damage
the radiator and its hose connectors.

RADIATOR

RADIATOR INSPECTION
Remove the front upper cover. (  2-5)
Remove the front lower cover. (  2-5)
Remove the two screws and the air duct.
Radiator Tester
Radiator Tester
Screws
Air Duct
DINK 200
Radiator Cap
12-4