Table 20 Fibre Channel Switch Led Patterns (1Tb And 2Tb) - Quantum DXi8500 User Manual

Table 20 Fibre Channel Switch
LED Patterns (1TB and 2TB)
LED Name LED Color
Power Supply No light
Status (right)
Steady green
Power Status No light
Steady green
System Status No light
Steady green
Steady
amber (for
more than
five seconds)
Flashing
amber/green
Quantum DXi8500 User's Guide
Status of Hardware
Primary power cord is
disconnected or is not actively
powered, or power supply has
failed.
Power supply is operating
normally.
System is off or there is an
internal power supply failure.
System is on and power supplies
are
functioning properly.
System is off, boot is not
complete, or boot failed.
System is on and power supplies
are functioning properly.
Boot failed, the system is faulty.
Attention is required. A number
of variables can cause this status
including a single power supply
failure, a fan failure, or one or
more environmental ranges has
exceeded.
Chapter 2: Basic Operations
DXi8500 Components and Operations
Recommended Action
Verify the power supply is on
and seated and the power cord
is connected to a functioning
power source.
No action required.
Verify the system is on. If the
system is on, the unit is faulty.
Contact Technical Support.
No action required.
Verify the system is on and has
completed booting.
No action required.
Perform the following steps:
• Connect a serial cable to the
system.
• Reboot the system.
• Check the failure indicated on
the system console.
• Contact Technical Support.
Check the management
interface and the error log for
details on the cause of status.
Contact Technical Support if
required.
73