Figure 207 Network Page: Interface Details - Quantum DXi8500 User Manual

Figure 207 Network Page:
Interface Details
Quantum DXi8500 User's Guide
Click Undo to revert to all current Bonding Details changes to the
last update.
Configuring Interface Details
Under IP Address Configuration > Interface Details, configure VLAN
tagging and jumbo Ethernet frame settings for each port or device (see
Figure 207):
1 If necessary, click the Show link to show the interface details table.
2 For each device, select the check box to enable VLAN tagging for the
device. (Or clear the check box to disable VLAN tagging for the
device.)
VLAN tagging allows you to assign a device to a virtual local area
network (VLAN). With VLAN tagging, you can route different traffic
types (management, data, and replication) over different VLANs,
making sure traffic types do not mix.
If VLAN tagging is enabled, enter the VLAN Tag ID for the device.
(Valid values are 2 to 4094. You can assign only one tag ID to a
device.)
Note: If you cannot select the VLAN check box, try adding an
interface IP address for the device first (see
Interface IP Addresses
Note: The maximum allowed number of VLAN tag IDs is 64. If you
attempt to add more than 64 VLAN tag IDs, an error
displays.
Note: To maintain connectivity, the switch ports connected to the
DXi must be configured to accept the correct VLAN tag ID.
Chapter 9: DXi8500 Configuration
on page 374).
System
Configuring
373