Figure 206 Network Page: Bonding Details - Quantum DXi8500 User Manual

Figure 206 Network Page:
Bonding Details
Quantum DXi8500 User's Guide
Note: You must specify a DNS IP address if you plan to use
hostname format when configuring an NTP time server,
outgoing e-mail server, replication sources and targets, and
other information.
Note: The DNS Suffix Search List and DNS IP Addresses cannot be
modified if the DXi8500 is currently joined to a Windows
domain. To disjoin a Windows domain, see
on page 271.
Configuring Bonding Details
Under IP Address Configuration > Bonding Details, configure bonded
devices (see Figure 206):
1 If necessary, click the Show link to show the bonding details table.
2 For each available bonded device (bond0, bond1, and so on), select
two or more Ethernet ports with the same link speed to assign to
the bond. Or select Not Bonded to leave a port unassigned to any
bond.
If no ports are assigned to a bond, the bond cannot be configured.
That is, settings cannot be entered for the bond in the Interface
Details or IP Address tables because no Ethernet ports are assigned
to the device.
All ports assigned to the same device are bonded together into a
single logical port. For example, if you select bond0 for port eth0
and port eth1, both ports are bonded together in the bond0
device. A bonded device can contain two or more ports.
Chapter 9: DXi8500 Configuration
Windows Domain
System
371