Intermec EasyCoder PF2i Service Manual page 253

Setup Mode Overview (FP v8.10)
SETUP:SETUP:
These menus will only be displayed when an optional Double Serial or Serial/Industrial interface board is installed.
SER-COM, UART2
In case of a Double Serial interface baord, also see the overview for Serial Communication, uart3.
SER-COM, UART2:
SER-COM, UART2:
PROT ADDR
BAUDRATE
PROT ADDR:
BAUDRATE;
DISABLE
DATA TO HOST:
9600 BAUDRATE;
ENABLE
19200 BAUDRATE;
Only displayed in case
38400 BAUDRATE;
57500
BAUDRATE;
115200 BAUDRATE;
300 BAUDRATE;
600 BAUDRATE;
1200 BAUDRATE;
2400
BAUDRATE;
4800
FLOW CONTROL:
ENQ/ACK
ENQ-ACK:
DISABLE ENQ/ACK:
ENABLE
SER-COM, UART2:
TRANS BUF
TRANS BUF:
[1024]:
Intermec EasyCoder PF2i, PF4i, and PF4i Compact Industrial—Service Manual
SER-COM, UART2:
CHAR LENGTH
CHAR LENGTH
8
CHAR LENGTH
7
of RS485.
Menus inside this dotted box are not displayed in case of RS485 on "uart2:".
FLOW CONTROL:
XON/XOFF
XON/XOFF:
DATA TO HOST
DATA TO HOST:
DISABLE
DATA TO HOST:
ENABLE
SER-COM, UART2:
CONNECTED HW
CONNECTED HW:
RS232
Read-only
Appendix A—Program Overviews
SER-COM, UART2: SER-COM, UART2:
PARITY STOP BITS
PARITY: STOP BITS:
NONE 1 STOP BITS:
PARITY:
EVEN 2
PARITY:
ODD
PARITY:
MARK
PARITY:
SPACE
SER-COM, UART2:
NEW LINE
NEW LINE:
CR/LF
NEW LINE:
LF
NEW LINE:
CR
XON/XOFF:
DATA FROM HOST
DATA FROM HOST:
DISABLE
DATA FROM HOST:
ENABLE
SER-COM, UART2:
PROTOCOL ADDR.
PROTOCOL ADDR.
[1]:
Only displayed in case of
RS485 on "uart2:".
Enter printer's protocol
address (0–31).
Ser-Com, uart2
SER-COM, UART2:
FLOWCONTROL
FLOW CONTROL:
RTS/CTS
RTS/CTS:
DISABLE
ENQ/ACK:
ENABLE
SER-COM, UART2:
REC BUF
REC BUF:
[1024]:
245