Intermec EasyCoder PF2i Install Manual
Label taken sensor kit
Hide thumbs
Also See for EasyCoder PF2i:
- Service manual (270 pages) ,
- User manual (194 pages) ,
- Installation instructions manual (72 pages)
Advertisement
Quick Links
Advertisement
Subscribe to Our Youtube Channel
Related Manuals for Intermec EasyCoder PF2i
Summary of Contents for Intermec EasyCoder PF2i
- Page 1 Label Taken Sensor Kit...
- Page 2 Service support: +46 31 869500 The information contained herein is proprietary and is provided solely for the purpose of allowing customers to operate and/or service Intermec manufactured equipment and is not to be released, reproduced, or used for any other purpose without written permission of Intermec.
-
Page 3: Table Of Contents
Contents Introduction ... iv Printer Firmware ... iv Installation Kit ... iv Physical Installation Installation Instructions ... 2 Controlling and Adjusting the LTS Intermec Fingerprint v8.xx... 6 IPL v2.xx ... 7 Label Taken Sensor Kit Installation Instructions Preface... -
Page 4: Introduction
Introduction This Installation Instructions booklet describes how to install a label taken sensor (LTS) in an EasyCoder PF2i, PF4i, or PF4i Compact Indus- trial printer, how to adjust the sensitivity, and how to control it in either Intermec Fingerprint or IPL. -
Page 5: Physical Installation
Physical Installation This chapter describes how to physically install the Label Taken Sensor (LTS) kit in a PF2/4i-series printer. Label Taken Sensor Kit Installation Instructions... -
Page 6: Installation Instructions
• Turn the printer upside down on a soft cloth or similar to avoid scratches. • Using a #T20 Torx screwdriver, remove the six screws indicated below and lift away the bottom plate and right-hand door assembly. - Page 7 • Fit the sensor and bracket to the lug at the printer’s front while rout- ing the cable between the two rails on the center section and through the slot in the center section as illustrated below. Mounting lug Sensor...
- Page 8 Chapter 1 — Physical Installation Label Taken Sensor Kit – Installation Instructions...
- Page 9 Control and Adjustment This chapter describes how to control and adjust the label taken sensor in printers running either Intermec Fingerprint v8.00 (or later) or IPL v2.00 (or later). Label Taken Sensor Kit Installation Instructions...
-
Page 10: Intermec Fingerprint
The sensitivity can be adjusted in the Setup Mode or by using setup fi les or setup strings (see Intermec Fingerprint v8.xx, Programmer’s Reference Manual). There are no straps or potentiometers for adjusting the LTS. - Page 11 Chapter 2 — Control and Adjustment Controlling the LTS The label taken sensor works when the printer is in self-strip mode. The self-strip mode can be enabled or disabled using the following IPL com- mands: enter print/confi guration mode <STX>R<ETX>...
- Page 12 Chapter 2 — Control and Adjustment Label Taken Sensor Kit – Installation Instructions...
- Page 14 Intermec Printer AB *1-960599-00*...
Need help?
Do you have a question about the EasyCoder PF2i and is the answer not in the manual?
Questions and answers