Install The Touch Panel Controller - Christie CP4230 User Manual

Section 2: Installation and Setup
2. Add the extension rods to the standard feet.
3. Thread the extended feet into the cinema projector baseplate. Adjust the feet until the desired tilt is
achieved.
4. Turn each lock nut until it fits tight against the cinema projector to lock the feet in place.
1.
2.7

Install the Touch Panel Controller

1. Loosen the mounting arm so that the end fits over the ball joint located on the rear panel of the cinema
projector.
2. Tighten the mounting arm until it fits tightly on the joint.
3. Connect the cable from the TPC to the connector on the rear panel of the cinema projector.
4. Adjust the angle of the TPC.
2-8
Prop up rear of projector
Remove rear feet
2.
19 mm wrench
Add foot extension rod
3.
CP4230 User Manual
020-100621-03 Rev. 1 (05-2014)