Christie CP4230 User Manual page 169

Power (PWR)
Change the power state of the cinema projector. Data can be:
3 - Power OFF - all electronics power OFF except cinema projector Control Module (PCM). It's also called
Standby mode.
1 - Power ON - cinema projector is powered ON with lamp ON.
0 - Full power mode - cinema projector is ready for lamp ON.
11 - Warm up. Read only, it's middle status between standby and full power mode.
10 - Cool down. Read only, cinema projector will stay in cooling down mode for 15 minute after lamp is turned
OFF.
SUBCODE DESCRIPTION OF USE
COOL
Status of current cooling down timer. Read only command.
NONE
Select power state.
STAT
Status of current power state. Read only command.
EXAMPLES:
(PWR+STAT?) - Get cinema projector power status
(PWR+COOL?) - Get how many seconds left on cooling down mode
(PWR3) - Set the cinema projector to standby mode
(PWR0) - Turn the cinema projector ON and lamp OFF
(PWR1) - Turn the cinema projector ON and lamp ON
(PWR?) - Get the target power state from the latest command sent to the cinema projector. Target power state.
For cinema projector power states, refer to Table 3.1.
Remote Access Level (RAL)
Set the remote serial protocol access level for a serial communications port.
0 - No Access,
1 - Login Required,
2 - Free Access.
Default value is 1 - Login required.
SUBCODE DESCRIPTION OF USE
NONE
Set the access level on Ethernet all ports.
PRTA
Set the access level on RS232 port A.
EXAMPLES:
(RAL 0) Disable remote serial protocol access for all Ethernet ports
(RAL?) Get access level for Ethernet ports (RAL!0)
(RAL+PRTA 2) Set remote serial protocol access level on port A to free access
(RAL+PRTA?) Get access level (RAL+PRTA!2)
Reboot TPC (RBT)
Command for rebooting the TPC, requires argument 3.
SUBCODE DESCRIPTION OF USE
NONE
Reboot TPC, use 3 as argument other arguments have no effect.
CP4230 User Manual
020-100621-03 Rev. 1 (05-2014)
Appendix B: Serial API
Valid sections are
B-21