Christie CP4230 User Manual page 20

Section 2: Installation and Setup
forfeit some aim and stay more parallel to the screen. In such cases, some lens offset can reduce the key-
stone distortion.
3. Position the lamp power supply so that the cables reach the left side of the cinema projector.
4. Install and secure the lamp power supply (LPS) in the rack stand:
a. Remove the right (the operator's side) panel of the rack stand.
b. Remove the cross bar.
Snap 3 piece airflow duct
together using stand out pins
3.
c. Insert the LPS support into the rack stand and align the pins with the holes.
d. Lift the LPS into the frame.
e. Remove the bottom 10 panels from the back of the rack stand.
f. Assemble the three piece airflow duct (supplied with LPS). First snap the 2 "L" shaped parts together,
and then snap this into the 6 stand out pins of the third piece (flat panel).
2-6
2.
Lift LPS into frame
1.
Insert support frame
CP4230 User Manual
020-100621-03 Rev. 1 (05-2014)