Christie CP4230 User Manual page 69

Control
3: All Channels Button
4: Power
Power OFF
5: Lamp
Lamp OFF
6: Douser
Douser Closed
7: Aux Lens
Aux Lens OUT
8: Lens Adjust
9: Test Patterns
Disable
10: Operational Status
CP4230 User Manual
020-100621-03 Rev. 1 (05-2014)
Description
Displays 64 saved channels.
Turns the cinema projector on or off. Press off to place the cinema projector in
stand-by mode. To prevent accidental activation, you must press and hold the on
Power ON
or off buttons. A message displays in the title bar when the cinema projector
turns on or off.
Turns the lamp on or off. To prevent accidental activation, you must press and
hold the on or off buttons. A boot delay occurs if you select lamp on before
Lamp ON
pressing power on.
Opens or closes the douser.
Douser Opened
Engages or disengages the auxiliary lens. If the auxiliary lens mount is not
installed, the Aux Lens buttons are disabled. Engaging the auxiliary lens
Aux Lens IN
temporarily overrides the position settings defined in the Config 1 channel.
Controls the Intelligent Lens System (ILS) lens motors. Press to open the ILS
Adjust window. If the Intelligent Lens System is not installed, the Lens Adjust
button is not available.
Selects or disables test patterns. Press Select Test Pattern to open the Preferred
Test Patterns window.
Select Test Pattern
Displays the status of cinema projector functions including the cinema projector
Intelligence Board (PIB), TI Electronics the Integrated Cinema Processor Board
(ICP), Link Decrypter (LD), Internal Media Block (IMB), Standby Power, Main
Power, Run, and Marriage. A green LED indicates the system is functioning
correctly. A red LED indicates a critical error that you must correct. Click the
status LED to open the Status window and resolve issues.
Section 6: Cinema Projector Menus
6-3