Power Warnings; Power Cords And Attachments; Lamp Precautions; Contacting Your Dealer - Christie CP4230 User Manual

Section 1: Introduction
1.2

Power Warnings

To correctly install this cinema projector, a certified electrician must install a permanent a single-phase
connection from the cinema projector to the AC supply. You must operate the cinema projector at the
recommended voltage.
WARNING
Disconnect cinema projector from AC before opening any enclosure.
• DO NOT allow anything to rest on the power cord. Locate the cinema projector where the
cord cannot be damaged by people walking on it or by objects rolling over it. Never operate the cin-
ema projector if the power cable appears damaged.
• DO NOT overload power outlets and extension cords as this can result in fire or shock haz-
ards.
• Only qualified service technicians are permitted to open any enclosure on the product and
only if the AC has been fully disconnected from the product.

1.2.1 Power Cords and Attachments

WARNING
projector. Ensure that you are using a power cord, socket and power plug that meets the
appropriate local rating standards. 2) Use only an AC power cord recommended by Christie.
Do not attempt operation if the AC supply and cord are not within the specified voltage and
power range.
To avoid the risk of fire, shock, or personal injury, use only the attachments and accessories recommended by
Christie.
1.3

Lamp Precautions

Lamps used in the cinema projector are under high pressure and you must handle them with caution. Lamps
can explode and cause serious personal injury if they are dropped or mishandled.
DANGER
door is open.
Recommended protective clothing includes, but may not be limited to a polycarbonate face shield, protective
gloves, and a quilted ballistic nylon jacket or a welder's jacket. This equipment is included in included in the
Christie Protective Clothing Safety Kit #598900-095.
DANGER
whenever the lamp door is open or while handling lamp. 2) Ensure those within the vicinity of the
cinema projector are also equipped with protective clothing. 3) Never attempt to access the lamp while
the lamp is on. Wait a minimum of 10 minutes after the lamp turns OFF
projector off, disconnecting it from a power source, and opening the lamp door.
1.4

Contacting Your Dealer

1-2
1) A North American rated power cord is provided with each cinema
EXPLOSION HAZARD! Wear authorized protective safety clothing whenever the lamp
Lamp may explode causing bodily harm or death. 1) Always wear protective clothing
before
turning the cinema
CP4230 User Manual
020-100621-03 Rev. 1 (05-2014)