Crank Assembly Page; Disassembling And Assembling Engine; Removing And Installing Ribbed V-Belt - Skoda OCTAVIA Workshop Manual

OCTAVIA

Disassembling and assembling engine

Removing and installing ribbed V-belt

Notes:
♦ The illustration shows the belt drive of mod-
els not fitted with air conditioning.
♦ Before removing the ribbed V-belt, mark the
direction of running. If an already used belt
is fitted on again to run in the opposite direc-
tion, it may be destroyed. When installing the
belt, ensure it is correctly located in the belt
pulleys.
1 - Ribbed V-belt
♦ removing and installing ⇒ page 13-3
2 - 25 Nm
Edition 11.02
S00.5110.56.20
Crank Assembly
3 - Belt pulley of hydraulic pump
4 - Hydraulic pump
♦ removing and installing ⇒ Running
Gear; Repair Group 48
5 - 10 Nm + torque a further
♦ always replace
6 - Belt pulley
♦ can be installed only in one position -
holes are positioned opposite
7 - Tensioning element
♦ up to 07.97
8 - Tensioning element with vibration
damper
♦ from 08.97
9 - Bracket
♦ for injection pump, alternator, hydrau-
lic pump and AC compressor
10 - 45 Nm
11 - Alternator
12 - Guide pulley
13 - AC compressor
♦ do not open refrigerant circuit
14 - Cover
15 - Banjo bolt, 30 Nm
16 - Seal
♦ replace
17 - Pressure line
13
/ turn (90°)
1
4
------------ 13-1 ------------