Unit Connector; Power Switch; Charger Jack - Ko Propo EX-2 Instruction Manual

● Unit Connector
This product may be dismantled and therefore each unit
features their respective connectors. Dirty or damaged
connectors may result in malfunctions, so please handle them
carefully.
Do not touch the unit connectors with your fingers. If connectors
become corroded due to grime, they may become inoperable. If
storing the transmitter in dismantled form. After prolonged use, a
black residue may build up on the connectors. Use cotton swabs
dipped in cleaning alcohol to remove. KO Propo's Customer
Service Department also handles transmitter maintenance.
● Power Switch
This product features a safety lock. The Master Unit and Grip
Unit cannot be detached when the Power Switch is in the ON
position. Turn off the transmitter before dismantling.

Power Switch

● Charger Jack
When using the Xpansion and an expert grip unit,
A battery stand, a rechargeable battery, a battery
charger are necessary.
※ When using the Xpansion and an expert grip unit, A battery
stand, a rechargeable battery, a battery charger are necessary.
※ Unusable by the following set contents
No.10559 Basic grip unit
No. 80561 EX-2 Standard Edition
[How to Recharge]
Confirm that the power switch is in the OFF position. If only
using the Grip Unit, make sure that the connector cover is in
place.
Make sure the battery is securely connected. If the
connection is loose, the battery may not charge completely.
Securely connect the charger plug to the charger jack.
Begin charging using a current of less than 1A.
Quick Charger (Sold Separately)
If the Xpansion unit is not assembled or
used, do not use the LiFe/LiPo battery.
When using balance charger (optional BX-
10L balance charger), please note that
it cannot be charged via the charger
j a c k . R e m o v e t h e b a t t e r y p a c k f r o m
the transmitter and connect to balance
terminal.
Make sure the power switch is in the OFF position when charging.
If only using the Grip Unit, make sure that the connector cover is in
place. A short circuit may occur if the connector makes contact with
metal and lead to a serious accident. Use a current of less than 1A to
charge. Do not connect/disconnect the battery during charging. Take
note of the charger plug's polarity in order to avoid damage.
Do not attempt to charge if using alkaline batteries. Doing so
may result in battery leakage or cracking which will damage the
transmitter.
[Discharging the Battery Pack]
If using a battery pack, please note that it cannot be discharged via
the charger jack. Remove the battery pack from the transmitter to
discharge it.
8