D. 1.6 Sweeping Limited - Ravo 5 Series User Manual

RAVO 5-Series

D. 1.6 Sweeping limited

The sweeping limited indicator light (6) goes on when the emergency stop is operated, one of the cabin doors is open or there is an internal fault in the PLC.If
the sweeping limited indicator light is on, the sweeping function will be limited or stopped.
D. 1.7 Engine start indicator light
The engine start indicator light (7) goes on when the ignition key is switched on; the engine must not be started yet.Once the engine start indicator light goes out,
the engine may be started.
D. 1.8 Alternator indicator light
The alternator indicator light (8) goes on when the alternator is providing no power or too little to charge the battery.
Stop the sweeper immediately in a safe location and switch off the engine.Tilt the container manually and check the belts of the cooling fan and the alternator
drive.
If the belts are broken, have them replaced.Do not continue to drive with broken belts!
If the belts are still intact, contact your service department.
NOTE
IF THE CHARGING VOLTAGE DROPS BELOW 24 VOLTS THERE IS A DEFECT IN THE CHARGING CIRCUIT.CONTACT YOUR SERVICE DEPARTMENT.
D. 1.9 Coolant indicator light
The coolant temperature indicator light (9) goes on when the temperature of the coolant becomes too hot.
D. 1.10 Fuel indicator light
The fuel indicator light (10) goes on when the fuel level in the fuel tank is less than 15%.
D. 1.11 Engine oil pressure indicator light
The engine oil pressure indicator light (11) goes on when the engine oil pressure is too low.
WARNING
STOP THE SWEEPER IMMEDIATELY IN A SAFE LOCATION AND SWITCH OFF THE ENGINE.HAVE THE LUBRICATION SYSTEM CHECKED BY YOUR
SERVICE DEPARTMENT.
D. 1.12 Dipped beam indicator light
The dipped beam indicator light (12) goes on when the dipped beam switch is activated.
15 April 2015 3:03 pm
75