A CLEARANCE OF APPROXIMATELY 1 CM BETWEEN THE GROUND AND THE BRISTLES WHEN ADJUSTING THE FORWARDS AND SIDE ANGLES OF
THE BRUSHES. THE ADJUSTMENT POINT IS ON THE CENTRE LINE OF THE BRUSH.
F. 2.2 Forward angle of the brushes
The forward angle of the brush (with the rear of the brush slightly raised) must be set to prevent dirt from being thrown around and remaining on the road surface.
F. 2.2.1 Adjusting the forward angle of the brush:
• Unscrew the lock nut at position (2).
• Turn the adjusting nut (2) clockwise or anticlockwise.
• The brush angle will then be decreased or increased, respectively.
F. 2.3 Sideways angle of the brush
The sideways angle of the brush (with the inside of the brush slightly raised) must be set (the right-hand side may have a hydraulic adjusting mechanism instead
of a mechanical mechanism) to enable the brush to follow and clean the road surface and gutter profile in the required manner. Reasonably deep gutters can be
cleaned with just a small sideways brush angle.
F. 2.3.1 Adjusting the sideways angle of the brush:
• Unscrew the lock nut at position (1).
• Rotate the adjusting nut (1) on the left-hand side of the brush frame clockwise or anticlockwise.
• The brush angle will then be decreased or increased, respectively.
The brush angle on the right-hand side can be adjusted using a control button on the door console in the cabin.