Sony HVR-V1U Service Manual page 290

Digital hd video camera recorder
Hide thumbs Also See for HVR-V1U:
Table of Contents

Advertisement

3-5.
TG1 Height Adjustment
1) Replay the tracking standard (XH2-1).
2) Confirm that the waveform of the tape path is flat.
(Refer to Fig. 6-2-11, and 6-2-12.)
3) Confirm to see that there are gaps between top edge of the tape
and the TG1 flange, and bottom edge and the TG1 flange.
(Refer to Fig. 6-2-13.)
If the top and/or the bottom edge of the tape contacts with TG1
flange, adjust the height of the TG1 so that there is gap between
the edge of the tape and the flange.
If the height of the TG1 is adjusted, check the entrance side of
the tape path waveform (refer to Fig. 6-2-11, and 6-2-12). If
there is any change in the entrance side of the tape path
waveform, re-adjust the entrance side (TG2). (Refer to "3-4.
TG2/TG4 Guide Fine Adjustment.)
Drum
Measure the difference of
tape run at this position
Tape
TG1 guide
Fig. 6-2-13
HVR-V1J/V1U/V1N/V1E/V1P/V1C
TG1 guide
Clearance between tape
and upper/lower flanges
becomes equality.
6-126

Advertisement

Table of Contents
loading

This manual is also suitable for:

Hvr-v1nHvr-v1cHvr-v1jHvr-v1eHvr-v1p

Table of Contents