Sony HVR-V1U Service Manual page 393

Digital hd video camera recorder
Hide thumbs Also See for HVR-V1U:
Table of Contents

Advertisement

b Notes
• This function is effective only when the AUTO/
MAN switches of both CH1and CH2 are set to
MAN (p. 42).
• When [LINKED] is set, you can adjust the
volume with the AUDIO LEVEL dial of CH1
(p. 42).
x
INPUT1 LEVEL
You can switch between microphone and
line for input from the INPUT1 jack.
B MIC
Select to input audio signals from an
external microphone through the INPUT1
jack
.
appears on the status check screen.
LINE
Select to input audio signals from an audio
device through the INPUT1
appears on the status check screen.
INPUT1 TRIM
x
You can adjust levels of signal input from
the INPUT1 jack. This function is effective
only when [INPUT1 LEVEL] is set to
[MIC].
You can select from [0dB], [-8dB] and [-
16dB] (the default setting is [0dB]).
x
INPUT1 WIND
This function is effective only when
[INPUT1 LEVEL] is set to [MIC].
B OFF
Select to disable wind noise reduction.
ON
Select to enable wind noise reduction.
appears on the status check screen.
INPUT2 LEVEL
x
You can switch between microphone and
line for input from the INPUT2 jack.
B MIC
Select to input audio signals from an
external microphone through the INPUT2
jack
.
appears on the status check screen.
x
You can adjust levels of signal input from
the INPUT2 jack. This function is effective
only when [INPUT2 LEVEL] is set to
[MIC].
You can select from [0dB], [-8dB] and [-
16dB] (the default setting is [0dB]).
x
This function is effective only when
[INPUT2 LEVEL] is set to [MIC].
B OFF
jack
.
z Tips
• The INPUT TRIM function adjusts the input
level from an external microphone. When using
a highly sensitive microphone or recording loud
sound, set this to the minus side. When using a
less sensitive microphone or recording quiet
sound, set it to the plus side.
• When recording loud sound, the sound may be
distorted at either the input point or the
recording point. If it is distorted at the input
point, adjust the sound using the INPUT TRIM
function. If it is distorted at the recording point,
lower the total volume level manually.
• If you set INPUT TRIM too far to the minus
side, the microphone volume becomes too low,
resulting in a poor signal to noise ratio.
• Test the effect of the INPUT TRIM function
according to the microphone used or the sound
field of the recording site before actual
recording.
LINE
Select to input audio signals from an audio
device through the INPUT2
appears on the status check screen.
INPUT2 TRIM
INPUT2 WIND
Select to disable wind noise reduction.
ON
Select to enable wind noise reduction.
appears on the status check screen.
jack
.
69
Continued ,

Advertisement

Table of Contents
loading

This manual is also suitable for:

Hvr-v1nHvr-v1cHvr-v1jHvr-v1eHvr-v1p

Table of Contents