Locating a scene on a tape
1
2
b Note
• See page 136 for details on how to use the
Remote Commander.
Searching for a scene by date of
recording (Date search)
You can locate the point where the
recording date changes.
1
Set the POWER switch to VCR.
2
Press SEARCH M. 1 on the
Remote Commander repeatedly
to select [DATE SEARCH].
50
3
Press . (previous)/> (next)
2 on the Remote Commander to
select a recording date.
You can select the previous or the next
date of the present point on the tape.
Playback starts automatically from the
point where the date changes.
3
To cancel the operation
Press
Commander.
b Notes
• If one day's recording is less than 2 minutes,
your camcorder may not accurately find the
point where the recording date changes.
• The Date search will not function correctly
when there is a blank section between recorded
sections on the tape.
Searching for a recording start
point (Index search)
You can locate the point where an index
signal is recorded (p. 44).
1
Set the POWER switch to VCR.
2
Press SEARCH M. 1 on the
Remote Commander repeatedly
to select [INDEX SEARCH].
STOP
3 on the Remote