Sony HVR-V1U Service Manual page 277

Digital hd video camera recorder
Hide thumbs Also See for HVR-V1U:
Table of Contents

Advertisement

3-30.Mode Slider Ass'y
1. Removal procedure
1)
Remove the capstan cover 1 and remove the extension spring
(pinch limiter) 2.
2)
Remove the belt 3 from the conversion gear.
3)
Remove the mode slider ass'y 4 from the cam gear shaft in
the direction of the arrow.
Capstan cover
(Align the attaching
position)
When attaching, align the attaching
position using the two position setting
holes and groove.
Dowel
Two holes
Points to be noted
Apply grease when installing
Amount of grease: A ball of
grease of 1.0 mm diameter
Cam gear shaft,
Mode slider shaft
Cam gear shaft
Mode slider shaft
HVR-V1J/V1U/V1N/V1E/V1P/V1C
4 Mode slider ass'y
3 Belt
Cam gear shaft
Apply grease
4 Mode slider ass'y
LS chassis claw
2. Attachment procedure
1)
Apply grease on the cam gear shaft and the mode slider shaft.
Amount of grease: A ball of grease of 1.0 mm diameter.
2)
Engage the shaft B in the groove C and install the mode slider
ass'y 4 while aligning its side D and E engage it in the claw
of the LS chassis, then install the mode slider ass'y 6.
3)
Hook the belt 3 on the conversion gear and install it while
rotating the conversion gear.
4)
Install the tension coil spring (pinch limiter) 2 while being
careful of the orientation of the hook.
5)
And attach the capstan cover 1. (Don't re-use the capstan
cover.)
Conversion
gear
Mode slider shaft
Hook must face
upward.
6-119
Side face C
Side face D
Groove B
2 Extension spring (pinch limiter)
Hook must face
downward.
Rear view
1 Capstan cover
Don't re-use
the capstan
cover
Shaft B

Advertisement

Table of Contents
loading

This manual is also suitable for:

Hvr-v1nHvr-v1cHvr-v1jHvr-v1eHvr-v1p

Table of Contents