Oil Meter - KYMCO ZX Service Manual

16
. INSTRUMENT/SWITCHES/LIGHTS
INSTALLATION
The installation sequence is the reverse of
removal.

OIL METER

INSPECTION
Remove the met-in box. ( ð 12-4)
Remove the frame body cover. ( ð 12-4)
Disconnect the oil meter wire connectors and
remove the oil meter. Keep the oil meter float
at the lower position.
Measure the resistances between the wire
terminals as • and ‚ shown in the left figure.
Wire Terminals
Green/Red(+) Black(-)
Green(-) Black(+)
Oil Meter Operation Inspection
Connect the oil meter wire connectors and turn
the ignition switch ON.
Measure the resistance between the wire
terminals with the float at upper position.
Green/Red(+) Black(-)
16-3
Resistance
5 16Ω
About 340Ω
Oil Meter
G/R
•
Float
Light OFF
Light ON
ZX / SCOUT
Retainer
B
G
G
B
‚
4.5 1.0mm