Engine Oil/Oil Filter - KYMCO YUP 250 Manual

4
. LUBRICATION SYSTEM

ENGINE OIL/OIL FILTER

＊
Place the motorcycle upright on
•
level ground for engine oil level check.
Run the engine for 2_
•
minutes and check the oil level after the
engine is stopped for 2_
Remove the oil dipstick and check the oil
level with the oil dipstick.
If the level is near the lower level, fill to the
upper level with the recommended engine oil.
OIL CHANGE
＊
The engine oil will drain more
•
easily while the engine is warm.
Remove the oil drain bolt located at the left
side of the engine to drain the engine oil.
After the oil has been completely drained,
install the aluminum washer and tighten the
oil drain bolt.
Torque: 14.7N-m
Pour the recommended oil through the oil
filler hole.
OIL FILTER SCREEN
Drain the engine oil.
Remove the oil filter screen cap.
Remove the oil filter screen and spring.
Check the oil filter screen for clogging or
damage and replace if necessary. Check the
filter screen O-ring for damage and replace if
necessary.
Install the oil filter screen, spring, O-ring and
filter screen cap.
Torque: 14.7N-m
Recommended Oil: SAE15W40# API: SJ
Oil Capacity:
At disassembly:
At change:
Start the engine and check for oil leaks. Start
the engine and let it idle for few minutes, then
recheck the oil level.
4-3
www.PlanDeGraissage.org
3
3 minutes.
1.1 liter
0.9 liter
YUP 250
Oil Dipstick
Oil Drain Bolt
Oil Filter Screen Cap