KYMCO ZX Service Manual page 50

4
. LUBRICATION SYSTEM
Remove the rear carrier. ( ð 12-5)
Remove the frame body cover. ( ð 12-5)
Remove the oil meter connector.
Remove the two bolts attaching the oil tank.
Disconnect the oil inlet line.
Drain the oil inside the oil tank into a clean
container.
Remove the oil tank.
The installation sequence is the reverse of
removal.
*
• Connect the oil line properly.
• Bleed air from the oil pump after
installation.
• The oil tube clip (at the oil tank side)
must be locked from inside of the oil tube
joint.
Wire Connector
ZX /SCOUT 50
4-6