Service Precautions - KYMCO ZX Service Manual

2
. GENERAL INFORMATION

SERVICE PRECAUTIONS

n Make sure to install new gaskets, O-rings,
circlips, cotter pins, etc. when reassembling.
n When tightening bolts or nuts, begin with
larger-diameter to smaller ones at several
times, and tighten to the specified torque
diagonally.
n Use genuine parts and lubricants.
n When servicing the motorcycle, be sure to use
special tools for removal and installation.
n After disassembly, clean removed parts.
Lubricate sliding surfaces with engine oil
before reassembly.
n Apply or add designated greases and
lubricants to the specified lubrication points.
n After reassembly, check all parts for proper
tightening and operation.
n When two persons work together, pay
attention to the mutual working safety.
n Disconnect the battery negative (-) terminal
before operation.
n When using a spanner or other tools, make
sure not to damage the motorcycle surface.
n After operation, check all connecting points,
fasteners, and lines for proper connection and
installation.
n When connecting the battery, the positive (+)
terminal must be connected first.
n After connection, apply grease to the battery
terminals.
n Terminal caps shall be installed securely.
n If the fuse is burned out, find the cause and
repair it. Replace it with a new one according
ZX / SCOUT
2-2