KYMCO ZX Service Manual page 89

8
. KICK STARTER/DRIVE PULLEY/
CLUTCH/DRIVEN PULLEY
CLUTCH/DRIVEN PULLEY ASSEMBLY
First install the movable driven face onto the
driven face. Then, install the guide roller pins,
O-rings and a new oil seal.
Install the seal collar.
Bearing Driver Pilot
Outer Driver, 24x26mm
Driven Pulley
O-rings
Set the driven pulley, driven face spring and clutch
assembly onto the clutch spring compressor.
Compress the tool and install the 39mm drive plate
nut.
Tighten the 39mm nut to the specified torque.
Torque: 5.0 6.0kg-m
ZX / SCOUT
Oil Seal
Guide Roller Pin
8-16