KYMCO ZX Service Manual page 28

2
. GENERAL INFORMATION
Check battery circuit by
operating turn signals.
Connect indicator light
bulb to battery for bulb
inspection.
Check connectors for
proper operation.
Remove oil meter and
check operation of
indicator light by moving
float
Float up = Light off
Float down = Light on
2. Motor oil is sufficient but the indicator light remains on (Ignition switch ON)
Inspection/Adjustment
Check connectors for
proper connection.
Remove oil meter and
check operation of
indicator light by moving
float
Float up = Light off
Float down = Light on
FUEL GAUGE
1. Pointer does not register correctly (Ignition switch ON)
Inspection/Adjustment
Check battery circuit by
operating turn signals.
Signals operate
properly
Bulb lights
Good
Good
Symptom
Good
Good
Symptom
Signals operate
properly
Signals dim, remain
on or don't operate
Bulb does not light
Faulty
Faulty
Faulty
Faulty
Signals dim, remain
on or don't operate
ZX / SCOUT
• Burned out fuse
‚ Weak or dead battery
ƒ Faulty ignition switch
„ Loose or disconnected
connector
... Broken wire harness
•Burned out bulb
• Loose wire connector
‚ Broken wire harness
ƒ Incorrectly connected wire
• Faulty float
‚ Broken or shorted wire in
meter
Probable Cause
•
Loose or disconnected
connector
‚ Broken wire harness
ƒ Incorrectly connected wire
• Faulty float
‚ Broken or shorted wire in
meter
• Damaged oil tank
‚ Foreign matters in oil tank
Probable Cause
• Burned out fuse
‚ Weak or dead battery
ƒ Faulty ignition switch
2-24