KYMCO ZX Service Manual page 126

12
. FRAME COVERS
Remove the bolt attaching the front cover.
Remove the two screws on the back of the front
cover.
Remove the front cover downward.
Disconnect the headlight wire connector.
The installation sequence is the reverse of removal.
*
During removal, be careful not to pull the
joint claws forcibly and remove the front
cover downward.
HANDLEBAR FRONT/REAR COVER
REMOVAL
First remove the handlebar rear cover:
Remove the four screws attaching the handlebar
rear cover.
Disconnect the wire connectors.
Remove the handlebar rear cover.
Remove the two screws attaching the handlebar
front cover.
Remove the handlebar front cover.
The installation sequence is the reverse of removal.
FRONT RIGHT & LEFT LOWER COVERS
REMOVAL
First remove the front cover.
Remove the right and left side rails by removing the
two screws for each rail.
Remove the two bolts and three screws attaching
each of the front right and left lower covers.
Remove the front right and left lower covers.
The installation sequence is the reverse of removal.
*
When removing the right and left side rails,
pull them backward not to damage the joint
claws.
Front Cover
12-3
Bolt
Screw
Handlebar Rear Cover
Bolt
FLOOR BOARD REMOVAL
Remove the rear carrier. ( ð 12-5)
Remove the frame body cover. ( ð 12-5)
Remove the right and left side rails. ( ð 12-3)
Remove the battery cover and battery.
Remove the four bolts attaching the floor board to
remove the floor board.
Bolt