Kyocera FS 2020D Advanced Operation Manual page 118

>Quick Copy
?Harold
>Quick Copy
?Arlen
>Arlen
?Report
>Report
Copies
>Report
Copies
>Report
Delete
Using the Operation Panel
Printing Additional Copies using Quick Copy
1
while Job Box > is displayed.
Press
2
Press
entered in the printer driver (Harold, in this example) also appears.
3
Press [OK]. A blinking question mark (?) appears before the user
name.
4
Press
example.
5
Press [OK]. The job name entered in the printer driver (Report, in
this example) appear with a blinking question mark (?) before the
letters.
6
Press
7
Press [OK]. The number of copies to be printed can be set. To
increase the copy count, press
001
.
8
Press [OK] to finalize the copy count. The printer prints the specified
number of copies for the job.
Deleting a Quick Copy Job
1
Follow steps 1 through 6 in the above section to let the title of the job
to be deleted displayed.
2
When the title of the job to be deleted is displayed, e.g. Report,
press [OK]. The cursor (_) below the copy count starts to blink.
001
3
Press
4
Press [OK]. The message Processing appears and the stored
quick copy job is deleted.
Using Proof-and-Hold
When you print multiple copies, this mode first prints one copy so that
you can proof it before continuing to print the remaining copies. Since
you can proof the printouts before printing the remaining copies,
wastage of paper can be reduced.
The printer prints one copy and, at the same time, saves the print job on
the hard disk/RAM disk. You can also change the number of copies
when resuming printing from the operation panel.
When the printer is turned off, all stored jobs will be deleted.
Note
Refer to the KX Printer Driver User Guide for the driver
settings.
repeatedly until >Quick Copy appears. The name
or
to display the desired user name, Arlen, in this
or
or to scroll to the desired job title.
; to decrease the copy count, press
repeatedly until Delete appears below the title.
7-21