Network (Network Settings) - Kyocera FS 2020D Advanced Operation Manual

Network
>TCP/IP
? Off
Using the Operation Panel

Network (Network settings)

This printer supports TCP/IP and TCP/IP (IPv6) protocols.
IP is an abbreviation for Internet Protocol. This printer routinely uses the
TCP/IP (IPv4) protocol, but provides a separate setting for the next-
generation IP, IPv6.
TCP/IP (IPv4) uses 32-bit IP addresses, but the rapid growth in the
number of Internet users has resulted in a shortage of IP addresses.
IPv6 was developed to expand the range of available IP addresses by
using 128-bit IP addresses.
The options available in the Network settings are as follows:
•
TCP/IP (IPv4 settings)
•
TCP/IP (IPv6) (IPv6 settings)
Note
Check with your network administrator when selecting the
network setting.
After all network related settings have been done, turn the
machine OFF and ON again. This is mandatory to make the
settings effective.
1
Press [MENU].
2
Press or
>
TCP/IP (IPv4 settings)
This selects the settings for TCP/IP (IPv4).
The TCP/IP system refers to the Internet system, which has a 5-layer
structure consisting of the interface layer, link layer, network (IP) layer,
transport (TCP/UDP) layer and application layer.
The interface layer is a key layer in the TCP/IP system that provides an
abstracted interface that is not dependent on the link (communication
line: frame relay or Ethernet, etc.) to the IP module (IP layer). This
means that the IP module can use this abstracted interface (which is not
dependent on the link type) to exchange IP packets back and forth with
the link layer.
The options available in the TCP/IP (IPv4) settings are as follows:
•
DHCP (DHCP setting)
•
IP Address (IP address setting)
•
Subnet Mask (Subnet mask setting)
•
Gateway (Gateway setting)
•
Bonjour (Bonjour setting)
IMPORTANT
The DHCP, IP address, subnet mask, gateway and
Bonjour menu options for TCP/IP are displayed when TCP/IP is
enabled.
1
while Network > is displayed.
Press
2
Press or
3
Press [OK]. A blinking question mark (?) appears.
repeatedly until Network > appears.
repeatedly until >TCP/IP > appears.
7-47