Kyocera FS 2020D Advanced Operation Manual page 176

>Change ID
00000001
>Change ID
001
>Change ID
_
OK?
002
>Change Password
****************
>Change Password
_
OK?
010
Using the Operation Panel
3
Once you enter the correct ID and password, the Admin (change)
screen appears. (E.g.: Where the administrator ID is 00000001)
Each time you press
appear in succession.
•
Change ID
•
Change Password
Note
If a change is required, refer to the procedures in
Change ID (Administrator ID change) and Change Password
(Administrator Password change) below.
4
Press [OK] again. The administrator ID and password are
confirmed.
5
Press [MENU]. The display returns to Ready.
Change ID (Administrator ID change)
You can use this to change the administrator ID.
1
In step 3 in Password (Administrator Password input) above, press
or while the Admin (Change) screen is displayed until
>Change ID appears. (E.g.: Where the administrator ID is 001)
2
When you press [OK], a blinking cursor (_) appears.
3
Press or to increase or decrease, respectively, the value at the
blinking cursor. Enter the ID to be changed. Use
the cursor right and left. Enter an ID consisting of between 1 and 16
numbers.
4
Press [OK]. A confirmation screen appears. (E.g.: Where the
administrator ID is changed to 002)
5
Press [OK]. The new administrator ID is confirmed.
6
Press [MENU]. The display returns to Ready.
Change Password (Administrator Password change)
You can use this to change the administrator password.
1
In step 3 in Password (Administrator Password input) above, press
or while the Admin (Change) screen is displayed until
>Change Password appears.
IMPORTANT
The administrator password is not displayed.
2
Press [OK]. A blinking cursor (_) appears.
3
Press or to increase or decrease, respectively, the value at the
blinking cursor. Enter the password to be changed. Use
move the cursor right and left. Enter a password consisting of
between 0 and 16 numbers.
4
Press [OK]. A confirmation screen appears. (E.g.: Where the
administrator password is changed to 010)
or , the following settings to be changed
and to move
and to
7-79