Kyocera FS 2020D Advanced Operation Manual page 138

>Font Select
Internal
>>Pitch
>>Pitch
>Code Set
IBM PC-8
>Code Set
?IBM PC-8
Using the Operation Panel
Character Pitch
You can set the character pitch for fixed fonts.
1
Press
2
Press
>
3
Make sure that Internal is displayed and press
4
Press
10.00 cpi
5
Press [OK]. A blinking question mark (?) appears.
10.00 cpi
6
Press
cursor. The character pitch can be set 0.44 and 99.99 characters per
inch, in 0.01 character-per-inch increments. Use
cursor right and left.
7
When the desired size is displayed, press [OK].
8
Press [MENU]. The display returns to Ready.
Code Set (Setting the code set)
You can change the character code set. Available character code sets
vary depending on the current font. (The default is IBM PC-8.)
1
Press
2
Press
3
Press [OK]. A blinking question mark (?) appears.
4
Press
5
Press [OK].
6
Press [MENU]. The display returns to Ready.
while Print Settings > is displayed.
repeatedly until >Font Select > appears.
or
repeatedly until >>Pitch appears.
or
or to increase or decrease the value at the blinking
while Print Settings > is displayed.
repeatedly until >Code Set appears.
or
or until the desired character code set appears.
.
or to move the
7-41