Kyocera FS 2020D Advanced Operation Manual page 153

>>RAM Disk Size
>Hard Disk
7-56
RAM Disk Size (Setting the RAM disk size)
Use this procedure to set the amount of memory used for the RAM disk.
IMPORTANT
RAM Disk Mode
1
Press
2
Press [OK]. The message display shows a blinking cursor (_). Press
119MByte
512.
to
This range varies depending on the total memory size of the printer.
The setting exceeding this range is automatically adjusted to the
maximum RAM disk size.
3
When the desired RAM disk size is displayed, press [OK].
4
Press [MENU]. The display returns to Ready. Turn the printer off
and then on again. The selected RAM disk size is activated after the
printer is restarted.
Hard Disk (Using the optional hard disk)
Installing the optional hard disk into the printer allows you to perform the
following operations on the hard disk.
•
Format (Formatting hard disk)
When an optional hard disk is inserted into the printer for the first time, it
must be formatted before use.
This menu is displayed only when the optional hard disk is installed on
the printer.
1
Press
2
Press
>
The RAM Disk Size menu option only appears when
is set to On .
while >RAM Disk Mode On > is displayed.
to display the desired size. Definable RAM disk size is 001
or
Use and to move the cursor right and left.
Note
Note If the optional hard disk is installed in the printer, the
Job Box will be available.
while Device Common > is displayed.
repeatedly until >Hard Disk > appears.
or
Using the Operation Panel